Toradex

Sort By:  
  • toradex oak IO module ()
    The Oak IO is a USB attached digital input / output board. Each of the 24 I/Os can be configured 
    individually to act as CMOS input, CMOS output or open drain I/O. The logic level of all I/Os can 
    be set to 3.3V or 5V by a single jumper. 
    8 of the 24 I/O lines are ESD protected and have disconnectable interfaces. The mating connectors 
    feature screw terminals to allow a quick attachment of bare wires. These I/O lines are provided 
    with pull up resistors to allow direct sensing of switches without external circuitry. 
    For the other 16 I/O lines, a pin header with a 2.54mm pitch is provided for a simple connection 
    of the inputs and outputs. 
    The output lines can be set with a maximum USB latency of 1ms. The report rate for reading the 
    I/O pins is user adjustable from 1ms to 65s. The minimum USB latency for reading the inputs is 
    therefore 1ms. 
    The Oak IO can be integrated in a custom application very easily. The operating power as well as 
    real time input/output data and uncritical device configuration data are all transferred through a 
    simple USB cable. The very low power consumption, including automatic entering into sleep mode, 
    allows using the device not only in fixed installation, but also in mobile applications. 
     
    Add to Cart
    50.00€
  • toradex oak 10V module ()
    The Oak 10V is a USB attached analog to digital converter board with 8 single-ended channels or 
    4 pseudo-differential channels. The ADC board can run at a sampling rate of up to 1kHz 
    independent of the number of used channels. Voltages between -10V and +10V can be measured 
    with a resolution of approximately 5mV (12 bit ADC)
    The analog inputs are completely isolated from the USB circuit. There is no isolation between the 
    analog input channels because they have a common ground. To simplify installation, the analog 
    inputs feature disconnectable interfaces. The mating connectors have screw terminals to allow for a 
    quick attachment of bare wires. 
    The Oak 10V can be integrated in a custom application very easily. The operating power as well as 
    real time ADC data and uncritical device configuration data are all transferred through a simple 
    USB cable. The very low power consumption, including automatic entering into sleep mode, allows 
    using the device not only in fixed installation, but also in mobile applications. 
    Add to Cart
    50.00€
Per Page      1 - 2 of 2

Powered by Abantecart eCommerce Solution